91 616 58 14
Industrial Division > Probes & Instruments > Combustion|
Process & Power For use in furnaces, boilers, incinerators, power plants, fired heaters, and kilns: The Eucon sensors systems -- Reference Air Box, Transmitter or Controller, and oxygen sensor -- will benefit your company immediately by helping you safely maintain the most efficient fuel/air ratio. Our oxygen sensors install directly in the "Hot Zone" for the most precise and most reliable oxygen measurement.
The processes described below are specially well suited for our products
Carburizing, and Carbo-Nitriding or Nitrocarburising: These well-established high-temperature atmosphere heat treating processes for the surface or "case" hardening of steel utilize some or all of a variety of EUCON products. Our Magnum, Carbonseer, or AACC zirconia oxygen sensors and our complete line of instruments have been leaders in the industry and enabled increasingly more precise control of the heat treatment process.
Nitriding: Gas Nitriding is an alternative to ion or plasma nitriding and improves wear and fatigue resistance with low distortion. The technology runs at a lower temperature than carburizing or carbonitriding, and is characterized by extremely long cycles, often exceeding 100 hours.
Vacuum: The vacuum process is used for a variety of metallurgical uses such as Bright Annealing, Solution Heat Treating, Brazing, Tempering, Stress Relieving, etc. When atmosphere control is important, for example to avoid de-carburization, EUCON`s carbon probes (Magnum and Carbonseer), and instruments will have a significant role to play in the success of the operation.
ReDox: EUCON ReDox Setpoint Controller is often used in conjunction with an oxygen probe for ReDox applications including brazing, sintering, glass-metal or glass-ceramic sealing, and neutral hardening in N2-H2 or exothermic atmospheres. Depending on the amount of enrichment gas that is required, an on-off solenoid valve may be sufficient. In some cases, a proportional control valve is necessary to maintain consistent conditions within the furnace or retort.
Sintering and Brazing: Powder metal sintering can be applied to both ferrous and non-ferrous metals, and can utilize either a neutral or a carburizing atmosphere. In all cases, a reducing atmosphere must be maintained during the process to prevent oxidation. The reducing gas atmosphere is usually created and maintained by the addition of hydrogen to an inert gas such as nitrogen or argon. The process typically runs at a high temperature, between 2000ºF to 2100ºF. Zirconia probes like EUCON Magnum and Carbonseer can be used in a sealed "reheat well" to control the dew point of the process and maintain a reducing atmosphere at all times.
Annealing: Although often not suited for control by means of traditional high-temperature zirconia oxide carbon probes, EUCON has annealing solutions including simple "recipe control" using our instrumentation product line. |
Access to the news of Medipro.
You can learn about the latest news related to our industry.
See News 
